Lamp With Quartz Diodes Sun 5 Plus Smart 2.0

The original SUN 5 Plus lamp with new quartz diodes. What are quartz LEDs? This is a new generation of diodes that have higher efficiency than conventional ones. Due to more diffused light, materials set much better, which means that craftsmen will spend less time drying various materials. Quartz LEDs look much more expensive and modern in appearance. Quartz is not subject to “burnout” and is resistant to ultraviolet radiation (the problem with LEDs in previous generation lamps is caused by the fact that the silicone in the diodes is not resistant to ultraviolet radiation, which led to a gradual “burnout” of the LED, reducing drying efficiency over time.) The heating temperature of the LED is reduced, which reduces the risk of failure. Also, the new LEDs have a more pleasant and delicate glow than the old ones. Functions of the SUN 5 Plus lamp buttons: “10s” - Timer for 10 seconds. “30s” - Timer for 30 seconds. “60s” - Timer for 60 seconds. “99s Low heat mode” - the device itself gradually increases the power: the first increase after 30 seconds, the next one after 50 seconds to maximum. The temporary memory function works for buttons: "10s", "30s" and "60s". The lamp remembers the mode when you press the corresponding mode button and hold it for about 2 seconds. Repeated long pressing for 2 seconds or pressing other buttons with a timer will clear the memory. The lamp is turned on mechanically, by pressing the buttons on the body, or automatically, using the built-in sensor. When turned on by the sensor, the lamp operates for 99 seconds. The lamp also turns off automatically by the sensor or by pressing the operating time button. The dual light source technology covers a wider spectrum of the ultraviolet range and is suitable for the polymerization of gel polishes, hard gels and acrylics. The lamp is also suitable for thick and dense products, for complex extensions and aquarium designs. 36 LEDs are evenly distributed throughout the body inside, which allows you to dry the entire surface of the nail plate for both manicure and pedicure. The lamp can be used continuously for 600 seconds (10 minutes), after which it needs the same amount of time to cool down. If you need to work longer, we recommend using two lamps alternately, this will extend the life of the lamp and make the process more convenient for your customers. At the bottom of all original lamps there is a seal with a bar code, which matches the seal with a bar code on the lamp box. It is important to retain the barcode for the duration of the warranty. The guarantee is provided only if there is a seal with a bar code without traces of its re-sticking. Technical characteristics: Lamp type: LED Number of diodes: 36 pcs. Timer: 10, 30, 60, 99 seconds Wavelength safe for human health: 365-405 nm Weight: 750 g. Housing material: plastic Dimensions (l/w/h): 237/208/114 mm Power supply cord length: 148.5 cm Equipment: LED lamp, adapter, instructions.